Freezer Replacement Doors for Walk-Ins and Standard Sizes

Walk-in freezer replacement door prices at ELT Custom Coolers range from $1,250 to $12,500 depending on door type, size, and frame option. Swing doors start from $1,250 for standard sizes up to 60"x84", while prehung sliding doors range from $4,000 to $12,500 for openings up to 96"x120". Equipment financing is also available through myCloudFunding.

Yes, ELT Custom Coolers stocks 51 prehung walk-in freezer swing door variants and 7 sliding door SKUs, all available for immediate purchase and ready to ship across the USA. Standard widths from 30" to 60" and heights from 76" to 84" are covered. Custom sizes are also manufactured in-house for non-standard openings.

A heated frame (or heated jamb) freezer door uses embedded heating elements around the door frame to prevent frost build-up, ice-up, and door-stick — common problems in commercial freezers with frequent traffic. If your current door frosts shut, sweats, or accumulates ice at the jamb, a heated frame replacement is strongly recommended to maintain efficiency and safe access.

ELT Custom Coolers stocks swing doors in widths of 30", 32", 34", 35", 36", 38", 40", 42", 47", 54", and 60", with heights of 76", 78", 80", and 84". Sliding doors are available in sizes from 47"x78" up to 96"x120". Custom sizes are available for non-standard walk-in freezer openings.

A standard frame mounts to the face of the walk-in panel or wall opening, while a plug frame is designed to insert into the opening itself, sitting flush with the panel surface. Plug frames are often used when the surrounding panel structure needs to remain clean and unobstructed. Both are available with or without heated jamb options from ELT Custom Coolers.

Prehung walk-in freezer doors from ELT Custom Coolers are designed for fast drop-in installation. Because the door arrives pre-assembled with the frame, header, and hardware included, experienced refrigeration contractors typically complete the swap in a few hours. No on-site door or frame fabrication is required, minimizing walk-in freezer downtime during replacement.